Vesco Turbinator-2, Руководство по сборке

Страница: 3 / 19

Clean off excess epoxy before it dries with denatured alcohol. Remove the masking tape before the epoxy sets
and clean the area as needed.
3) Locate the control ailerons, rudder and elevators along with the pin hinges for them.
Check the fit of each hinge into the control surface. Also check the fit into the adjoining surface such as
wings and stabs. Will need to remove a bit of the covering around holes as needed.
With slow set epoxy or Hysol, glue the hinges into the control surface first and let them dry completely before
gluing to the corresponding wing or stab. Add a VERY SMALL drop of oil to the hinge pin prior to gluing to
insure the glue doesn’t bind the hinge. Do not get any oil on the shaft of the hinge. If you do clean it off with
alcohol.