Vertiv
|
NetSure V200D50 DC Power Retrofit Installation & User Manual (UM486527803)
|
Rev. F
28
Rectifiers can be inserted or removed with power applied (hot swappable).
Procedure
1.
Performing this procedure may activate external alarms. Do one of the following. If possible, disable
these alarms. If these alarms cannot be easily disabled, notify the appropriate personnel to disregard
any future alarms associated with this system.
2.
Remove the front cover panel from the Mounting Frame by first loosening the two captive fasteners.
Refer to
3.
On the Rectifier to be removed, click the handle in order to pop it forwards out of the Rectifier front
panel. This will retract the latch mechanism located on the underside of the Rectifier and thus unlock
the Rectifier from the shelf. Refer to
4.
Slide the rectifier out of the Mounting Frame.
5.
Place the replacement Rectifier into the mounting slot without sliding it in completely.
6.
Click the handle in order to pop it forwards out of the Rectifier front panel (this will also retract the latch
mechanism located on the underside of the rectifier).
7.
Push the Rectifier completely into the shelf.
8.
Push the handle into the front panel of the Rectifier. This will lock the module securely to the shelf.
9.
After the Rectifier is physically installed in the Mounting Frame, it is ready for operation immediately
after power is supplied to it. Verify that the rectifier is operating normally.
10.
On the Power System controller (MCA), update the system inventory as necessary. Refer to the Power
System documentation for a procedure.
11.
Ensure that there are no local or remote alarms active on the system.
12.
Install the front cover on the Mounting Frame. Secure by tightening the two captive fasteners. Refer to
Replacing the Rectifier Interface Circuit Card
One Rectifier Interface Circuit Card, Part No. 547568, is located within the V200 Retrofit Mounting Frame. To
replace this circuit card perform the following procedure.
CAUTION!
When performing any step in this procedure that requires removal or installation of
hardware, use caution to ensure no hardware is dropped and left inside the cabinet; otherwise service
interruption or equipment damage may occur.
WARNING!
Circuit cards used in this equipment contain static-sensitive devices. Read the Static
Warning page at the front of this document before performing the following procedure.
NOTE!
When performing any step in this procedure that requires removal of existing hardware, retain all
hardware for use in subsequent steps.
