Vertiv eSure 565391, Руководство по установке

Страница: 23 / 34

Vertiv
| eSure™ Power Extend Converter Mounting Bracket Kit Installation Manual (IM565391) | Rev. A
23
Single Power Extend Converter Installation
NOTE!
Mounting bracket kit P/N 565391 with distribution panel 582127000 List AA is used in the
following procedure. Other kits and distribution panels similar.
To parallel power extend converters, refer to the procedure “Parallel Power Extend Converter Installation”
starting on page 28.
Procedure
[ ] 1. If the power extend converter is to be installed for a newly connected load, connect the load and
load return cables to the distribution panel for the position to be occupied by the power extend
converter. At the same time, connect the power extend converter return wire faston tab (P/N
565990) provided with the power extend converter to the distribution panel return busbar (use the
same location and hardware used for the return lead to the load). See
Figure 19 . Torque as
indicated in Figure 19 .
[ ] 2. If the power extend converter is to replace an existing circuit breaker in the distribution panel,
remove the circuit breaker and verify the load and return cables to the distribution panel for the
position to be occupied by the power extend converter are wired and labeled correctly. (It may be
advantageous, depending on the size and location of the return cables for each circuit to be
powered by the power extend converter, to loosen and temporarily move the load side cables for
easier access to the hardware on the return landing position studs.) Connect the power extend
converter return wire faston tab (P/N 565990) provided with the power extend converter to the
distribution panel return busbar (use the same location and hardware used for the return lead to the
load). See
Figure 19 . Torque as indicated Figure 19 .