Vertilux VTi, Инструкция по программированию, Страница: 3 / 14

2
vertilux.com
© 2018. Vertilux, Ltd. All Rights Reserved. Last revised: October 2018.
To start adjusting the motor limits, make sure that the 2 limit
setting buttons (red and blue) located on the motor head are
unlocked (fig. 1) . The buttons are unlocked when they “click”
once pressed.
Once both buttons are unlocked, you can start adjusting the
motor limits. If both buttons or at least one is locked, follow the
procedure on page 5 to reset the motor to factory default
settings before proceeding with the limit setting.
Make sure that the panels are approximately in the middle of
the track. To do this, remove the track COVER located on the
side of the motor, remove the GEAR , and pull the drive CHAIN
until the panels are in the middle of the track. Then place the
GEAR back (fig. 2) .
To adjust the limits it is necessary to use the VTi
®
Celtic Radio
Receiver & Transformer Wall Switch (6-700-AT-AC227) .
Make sure it is properly wired and installed (fig. 3) .
Initial programming sequence
Before starting...
Fig.1 . Limit setting buttons
Fig. 2 . Motor side
GEAR
CHAIN
COVER
L: Line
E: Ground
N: Neutral
100-240 V AC
Input Voltage
100-240 V AC
WALL CONTROL
(6-700-AT-AC227)
FRONT
STOP BUTTON
DIRECTION
BUTTONS
WALL CONTROL
(6-700-AT-AC227)
BACK
VTi
®
CELTIC MOTOR
Fig. 3 . Wiring Connection Scheme
24 V DC
Output Voltage
0,009 kW
6-710-SP-00XXX
SN: 324385 U = 24V DC
n= 59 U/mim