VX-110 O
PERATING
M
ANUAL
8
R
EPEATER
O
PERATION
The ARS (Automatic Repeater Shift) feature in the
VX-110
provides repeater shift of the
transmit frequency whenever you are tuned to a standard repeater subband (see diagram
below). When enabled, a small “–” or “+” will be displayed in the upper left-hand corner
of the display, signifying that repeater shift is active, and closing the push-to-talk switch
changes the display to the (shifted) transmit frequency.
Basic Operation
Automatic Repeater Shift (ARS)
To re-enable ARS:
Press the [
F
] key, then immediately press the [
M/V
(
SET
)] key to enter the Set mode.
Rotate the
DIAL
to select Menu Item #2 (“
ARS
”).
Press the [
F
] key to enable modification of the current setting.
Now rotate the
DIAL
to select “ON” (to enable Automatic Repeater Shift).
Press the
PTT
key to save the new setting and exit to normal operation.
Tone Burst
For repeaters using 1750-Hz burst tone access, you can configure the switch below the
PTT to send the access tone when this switch is pressed. See page 12 for details.
Manual Repeater Shift Activation
When a repeater shift is active, either “–” or “+” appears in the display. If neither appears
when tuned to a repeater output frequency, you can activate the shift manually:
Press the [
F
] key, then immediately press the [
M/V
(
SET
)] key to enter the Set mode.
Rotate the
DIAL
to select Menu Item #3 (“
RPT
”).
Press the [
F
] key to enable modification of the current setting.
Rotate the
DIAL
to select the desired repeater shift direction (
-RPT
,
+RPT
or
SIMP
).
Press the
PTT
key to save the new setting and exit to normal operation.