PAGE 29
STEP 13: INSTALLING TRIM ON THE GARAGE DOOR FRAME
ANGLE TRIM INSTALLATION:
Cut two pieces of Angle Trim to fit from the concrete slab to the top of the door jamb (bottom of the door header) for each
door. This will trim out the door jambs.
If you have a 9’ wide garage door Cut one piece of Angle Trim to fit the inside width of the garage door opening. (It
should be 9’ long). This will trim out the door header.
If you have two 9’ wide doors cut two pieces the width of the door opening.
If you have one 16’ wide garage door you will be using (1) 10’ piece of Angle Trim and you will need to cut a 6’-3” piece of
Angle Trim. The 6’-3” trim will overlap the 10’ piece 3” to trim out the under side of the door header.
Fasten the Angle Trim with Painted #12 x 1” Self-Drilling Screws with Rubber Washers every 2’.
ORDER OF INSTALLATION: (1) ANGLE TRIM, (2) J-TRIM, (3) SIDE J-TRIM, (4) TOP J-TRIM
2”
1 1/2”
ANGLE TRIM
DOOR HEADER ANGLE
TRIM: FOR 9’W DOORS, (1)
9’ PIECE.
FOR 16’W DOORS, (1) 10’
AND (1) 6’-3” PIECE.
OVERLAP 3”.
CUT DOOR JAMB ANGLE
TRIM TO FIT FROM SLAB
TO BOTTOM OF DOOR
HEADER.
DETAIL
USE #12 X1” PAINTED, SELF
DRILLING SCREW WITH RUBBER
WASHER.
FRONT
FRONT
#12 X 1” PAINTED, SELF-DRILLING SCREW
WITH RUBBER WASHER
© MSMP INC. 8-17-04
