Versalift VST-8000-I, Руководство оператора

Страница: 18 / 64

2-10
39026-03 02/17 VERSALIFT VST-8000/8500/9000/9500-I
RESPONSIBILITIES / SAFETY
ADDITIONAL SAFETY CONSIDERATIONS
1. Report any unusual occurrence during the
operation of the aerial lift that may require repair
or adjustment.
2. Keep the work space in the truck bed clean and
neat.
3. Avoid parking on soft surfaces. Soft surfaces
may suddenly collapse, shift, or sink beneath
the truck’s weight.
4. There is no insulating value in the fi berglass
platform without a platform liner.
5. No attempt should be made to clean, oil, or adjust
a machine while the machine is in motion.
6. If an aerial lift has set idle for an extended period
(i.e. overnight) or has been recently serviced,
cycle the aerial-lift through it’s full range of
motion several times. This procedure will force
any trapped air out of the hydraulic system. Do
not operate the lift from the platform until this
process is completed. Air trapped in the hydraulic
oil can cause lift movements to be erratic and
unpredictable.
7. Don’t operate any part of the unit (platform,
booms, outriggers, etc.) outside the work-site
barricades into the traffi c lanes. Set up adequate
cones or barricades to mark the boundaries of
the work-site to alert motorists and pedestrians.
8. Only qualifi ed mechanics are authorized to
service the aerial lift.
9. The polyester winch rope is not an insulator. Dirt,
grease, and moisture (humidity) make the rope
conductive.
10. Make a thorough check of the winch rope for
abrasive wear, pulled strands, cuts, and other
defects daily.
11. Replace the winch rope at the fi rst sign of damage
or deterioration. Use only non-conductive rope
of the size and type specifi ed.
12. Avoid shock loads. A shock load is caused by
jerking a line with a load or a sudden change in
rope tension from a light load to a heavy load.
13. Do not contact energized conductors with the
winch line. Contacting the load line with an
energized conductor could create a complete
path for electricity when the rope is extended to
the ground. This could cause death or serious
injury.
14. Avoid using the winch line to wrap or tie an object
for lifting. The hook attached to the end of the
winch line can damage or cut the rope. A sling
or lifting strap is recommended for this purpose.
15. Do not stand in line with a rope under tension. If
the rope should fail the recoil could cause serious
injury to personnel.
16. Inspect the jib-pole assembly to make sure the
various lock pins are secure.
17. Make sure the winch-rope coils are spooling
evenly to avoid clogging the winch or producing
shock loads when lifting a load.
18. Avoid contacting a spray or mist produced by a
high pressure hydraulic leak. This spray or mist
can puncture or become embedded beneath the
skin or contaminate the eyes. These conditions
requires immediate medical attention.
19. Hydraulic oil is fl ammable. Avoid any contact
between hydraulic oil and sources of high heat
or open fl ames.
20. Bodily contact with hot hydraulic oil can cause
serious burns which require immediate medical
attention.