Versalift VST-8000-I, Руководство оператора

Страница: 49 / 64

4-9
39026-03 02/17 VERSALIFT VST-8000/8500/9000/9500-I
OPERA
TION
assembly until it is centered over the boom rest.
Rotate the platform so the bottom of the platform
is centered over the platform support. Always stow
the lower boom before descending the outer/inner
boom assembly onto the boom rest. Release the
outer/inner boom control lever as soon as there is
firm contact with the boom rest pad. The platform
will also contact the spring-loaded platform support.
CAUTION:
FAILURE TO STOW THE
LOWER BOOM BEFORE DESCENDING THE
OUTER/INNER BOOM ASSEMBLY ON TO THE
BOOM REST WILL STRESS THE COMPONENTS
AND MAY CAUSE DAMAGE TO THE AERIAL LIFT.
DANGER:
ALWAYS WATCH FOR
PERSONNEL AND OBSTRUCTIONS WHEN
STORING THE AERIAL LIFT. A CRUSHING
INJURY TO PERSONNEL OR DAMAGE TO THE
UNIT CAN OCCUR.
To complete the storing procedure secure the upper
boom with the tie down strap, re-install boom cover
if equipped, retract the outriggers, and remove the
wheel chocks. Turn the electrical control system off
and disengage the PTO pump drive.
CAUTION
: TO PREVENT DAMAGE TO
THE UNIT DO NOT DRIVE THE TRUCK UNTIL
THE AERIAL LIFT IS STORED AND THE OUTER
BOOM IS SECURED WITH THE BOOM TIE DOWN
STRAP.
CAUTION
: DRIVING WITH THE PTO
ENGAGED MAY DAMAGE THE TRANSMISSION,
PUMP, AND/OR THE PTO.
AUTO BOOM LATCH (optional) – The automatic
boom latch is designed to open automatically when
the lift is operated. Stay clear of the latch as it may
move at any time depending on the hydraulic system
pressure.
Manual over-ride – In case of hydraulic system
failure, the auto boom latch may be operated
manually.
Over-ride Procedure:
1. Danger – Make sure the hydraulic power
source is off.
2. Release the spring plunger by rotating the “T”
handle.
3. Manually rotate the latch arm 90° clockwise
until it snaps and is held by the spring plunger.
To Release Over-ride:
1. Caution – The latch is spring loaded. Keep
fingers clear to prevent pinching.
2. Slightly rotate the latch arm clockwise to
remove the load from the spring plunger.
3. While holding the latch arm, pull the spring
plunger out and rotate the “T” handle to lock
the spring plunger in the “out” position.
4. Carefully allow the latch arm to rotate counter-
clockwise under spring power until it stops.
LIFTING EYE (OPTION)
This aerial lift is designed primarily as a personnel
lift. When tools or equipment are included with the
operator in the platform the combined weight must
not exceed the rated load capacity of the aerial lift.
DANGER:
NEVER EXCEED THE RATED
LOAD CAPACITY OF THE AERIAL LIFT.
STRUCTURAL DAMAGE OR INSTABILITY MAY
RESULT, CAUSING DEATH OR SERIOUS INJURY.
The optional lifting eye has been designed to
accommodate limited material handling. Always
extend the outriggers (if so equipped) and fully
retract the inner boom when using the boom lifting
eye. Boom movements should be smooth to avoid
swinging the load. Do not exceed the load limits
stated on the decal beside the lifting eye. Do not drag
the load with the lifting eye. This is a bad practice