Versalift 24, Руководство по установке

Страница: 13 / 23

Versa Lift
Installation - Assembly
(All Models)
13
Close
5. DOOR ASSEMBLY
Assemble the door down-stairs. Locate the door, door
braces, and fasteners shown in Fig. 25. Insert each screw
through a screw cover, the door panel, then the door
braces (see Fig. 25 inset). Note: Insert a 1/4 x 1” spacer
washer under the center holes on the short braces as
illustrated below.
NOTE: SHORT BRACES (2)
MUST GO ON TOP OF
LONG BRACES!!
10-32
LOCKNUT (8)
LONG BRACE (2)
DOOR PANEL (1)
IMPORTANT :
BRACE FLANGES SCREW
MUST ALL POINT COVER (8)
TO THE CENTER
OF THE PANEL!
10-32 x 5/8"
PHILLIPS
SCREW (8)
1/4 x 1”
WASHER (2)
Fig. 25
Assemble
Screw Cover
IMPORTANT: Assemble all braces with small flanges
pointing toward the panel center. Short braces must
go on top of long braces.
Fasten each screw with a
locknut and tighten all 8 screws. Close the screw covers.
Make sure they snap completely shut (Fig. 25 inset).
6. PLATFORM ASSEMBLY
The platform must be assembled down-stairs. Locate the
platform, 2 platform supports, 4 platform legs, ¼-20 x 2”
truss screws, and
short locknuts (Fig. 26). Note: The
platform top side has warning labels. Insert the plat-
form support into one of the left legs as shown (Fig. 26
inset). Align the hole in the leg with the hole in the outer
end of the support. Next insert a ¼-20 x 2” screw down
through the platform, leg and support (Fig. 26). Secure
screw with a
short locknut, but do not tighten until all
four screws are installed. When all legs are assembled as
shown in Fig. 26, tighten all of the screws and locknuts,
but do not over-tighten or you will collapse the tubing.
Locate the platform leg brackets, platform top brace, and
fasteners shown in Fig. 27. Install each bracket with 4
truss screws and
tall locknuts (Fig. 27 inset). Tighten as
above. Install the platform top brace with 2 truss screws
and
tall locknuts (Fig. 27). Tighten fasteners as above.
Fig. 27
1/4-20
TALL LOCKNUTS (2)
PLATFORM
TOP BRACE
1/4-20 TALL
LOCKNUTS (8)
1/4-20 x 1½"
TRUSS SCREW (2)
1/4-20 x 1-1/2"
TRUSS SCREW (8)
PLATFORM LEG
BRACKET (2)
PLATFORM
LEG
PLATFORM
SUPPORT
INSERT SUPPORT
INTO LEG. ALIGN
TO FIRST HOLE.
PLATFORM
PANEL (1)
PLATFORM
LEG (2 LEFT)
PLATFORM
LEG (2 RIGHT)
FOUR HOLES
IN PLATFORM
1/4-20 x 2"
TRUSS SCREWS (4)
LABELS UP
PLATFORM
SUPPORT(2)
1/4-20 SHORT
LOCKNUTS (4)
NOTE: SECOND (INSIDE)
HOLES ARE NOT USED.
Fig. 26