
11
30007230
VCS325SSBI/525SSBI Series Assembly
Step 6: Assemble the Grill Unit to the Enclosure
NOTE:
This step should be performed by two (2) persons wearing gloves.
Figure 5
Before positioning the grill unit into the prepared enclosure or insulated jacket, depending on the available
access, it may be necessary to temporarily disconnect the LP regulator or Natural Gas connector hose from
the steel fl ex line.
Carefully position the grill unit into the opening from the front and raised slightly, while ensuring the gas feed
tubing is fed through the hole provided in the bottom of the enclosure opening. Push the unit back into its fi nal
position and check for proper fi t.
Reattach the LP regulator or Natural Gas connector hose if it was removed and check all connections for
leaks. Reinsert the grease tray into its place.
CAUTION:
The end of the steel fl ex line should be clamped to the surrounding structure to prevent excessive
movement.
CAUTION:
Do not turn on the grill unit until after performing a leak check at all connection points and fi ttings.
Use a spray solution of 50% dish soap and 50% water onto all connection points and fi ttings. Formation of
bubbles indicates air leaks.
Figure 5
B518