- 9 -
GENERAL GLASS INFORMATION
Only glass approved for use in The CFM
Majestic Products Company products
may be used for replacement.
1. The use of substitute glass will void all product
warranties.
2. Care must be taken to avoid breakage of the glass.
Under no circumstances should this fireplace
be operated without the front glass or with a
broken glass. Replacement of the glass (with
gasket) as supplied by the manufacturer
should be done by a licenced qualified
service person.
OPERATING INSTRUCTIONS
LOUVRE REMOVAL
RFS22
Remove the front louvre assembly by lifting up and outward
on the assembly.
RFS32
To remove louvres first remove the two (2) screws (Fig. 13)
fastening the louvre assembly to the fireplace. Lift the
louvre assembly straight out sliding the back guides out of
the fireplace body. (To reinstall, reverse).
RFS22
1.
Remove frame window brass trim by lifting up and out.
2.
Remove decorative cover, which was at the bottom of
the frame window trim by loosening two (2) nuts on the
underside of the cover.
RFS32
1.
Remove the two (2) outer 3/8" nuts holding the frame
window brass trim in place. (Fig. 14)
2.
Remove the frame window brass trim by moving it
straight forward.
TRIM REMOVAL
GLASS REMOVAL
RFS22
1.
Remove frame window brass trim (See Trim Removal
section)
2.
Remove remaining bottom 3/8" nut at the bottom of the
frame window.
3.
Remove frame window by pulling it forward and up.
RFS32
1 . Remove frame window brass trim (See Trim Removal
section)
2.
Remove remaining bottom 3/8" nut fat the bottom of
the frame window.
3.
Remove 3/8" nut from each side of the frame window
(Fig. 14).
4.
Remove frame window by pulling it forward and up.
Fig. 14
OUTER NUTS
DRAWING 1
GLASS
FRAME
DRAWING 2
BOTTOM NUT
Side Nuts
RFS42
1 . Remove both Bay Window brass trims (See Trim
Removal section).
2.
Open two clamps underneath the Bay Window that
holds the Bay Window Frame and Glass Frame. (Fig.
15)
3.
Lift and unhook the Bay Window assembly at the top.
4.
Lift and unhook the Glass Frame at the top.
WINDOW
FRAME
PULL
CLAMP HOOK
PUSH
CLAMP HANDLE
Fig. 15
RFS42
The top louvre is assembled with the Bay Window Frame
and is not required to be removed.
For the RFS42 both front bay window glass and
rear window glass need to be installed for
proper performance. Under no circumstance
should this fireplace be operated without the
rear window glass or with broken glass.
Replacement of the rear glass (with gasket) as
supplied by the manufacturer should be done
by a licensed qualified person.
RFS42
Remove trim Bay Window, top and bottom by pulling
them from the unit. They are held with magnets.
Fig. 13
Front View
Screws
