20
20306756
380IDV Fireplace Insert
5. Align holes in the bottom of the left base log #2 with
two (2) pins on the left side of insert. Install left base
log.
Figure 20
LG766
rockwool
Left Front Log #2
Figure 20
INSERT INSTALLATION
4. Place rear log #1 against back of firebox.
Figure 19
INSTALL LOGS AND ROCK WOOL (EMBER
MATERIAL) IN FIREBOX
Before you begin
- This unit is supplied with seven (7)
ceramic fiber logs. Do not handle these logs with your bare
hands.
Always wear gloves to prevent skin irritation
from ceramic fibers.
After handling the logs, wash your
hands gently with soap and water to remove any traces
of fibers.
1. Open front door of firebox.
2. Break up rock wool (ember material) into dime-sized
pieces. Place evenly as shown. Do not exceed 1" layer.
Figure 18
3. Carefully remove the seven (7) logs from wrapping.
LG765
place rockwool
Rockwool
Areas
LG766
rockwool
Figure 18 -
Rockwool Placement
W
ARNING
The positioning of the logs is critical to
the safe and clean operation of this heater.
Sooting and other problems may result if the
logs are not properly and firmly positioned
in the appliance. Never add additional logs
or embellishments such as pine cones or
vermiculite to the heater. Only use the logs
supplied with the unit.
Failure to position the parts in accordance
with diagrams below or to use only parts
specifically approved for this heater may re
-
sult in property damage or personal injury.
LG767
Rear log #1
Rear Log #1
Figure 19
