![Vermont Castings 085-3173-8 Скачать руководство пользователя страница 8](http://html1.mh-extra.com/html/vermont-castings/085-3173-8/085-3173-8_assembly-and-operation-manual_1005898008.webp)
8
CONTACT US: 1-844-586-4660
ASSEMBLY PREPARATION
MAJOR CAUSES OF APPLIANCE FIRES ARE A RESULT OF POOR MAINTENANCE AND A FAILURE TO MAINTAIN
REQUIRED CLEARANCE TO COMBUSTIBLE MATERIALS. IT IS OF UTMOST IMPORTANCE THAT THIS PRODUCT BE
USED ONLY IN ACCORDANCE WITH THE FOLLOWING INSTRUCTIONS.
Parts are located throughout the shipping carton, including below the grill. Inspect the grill, parts, and hardware blister pack after removing from the
protective shipping carton. Discard all packaging materials from inside and outside of the grill before assembly, then review and inspect all parts by
referencing the parts list. If any part is missing or damaged, do not attempt to assemble. Shipping damage is not covered under warranty. Contact
Customer Service for parts: Monday through Sunday, 4 a.m. - 8 p.m. PST (EN/FR/ES).
WWW.VERMONTCASTINGSBBQ.COM | TOLL-FREE: 1.844.586.4660
IMPORTANT: TO EASE INSTALLATION, USING TWO PEOPLE IS HELPFUL (BUT NOT NECESSARY) WHEN ASSEMBLING THIS UNIT.
Tools required for assembly: screwdriver and wrench. Tools not included.
18
19
21
20
1A
1B
1
FITTING LEGS TO THE BARREL
PARTS REQUIRED:
1
x
Leg - Left Rear (#18)
1
x
Leg - Left Front (#19)
1
x
Leg - Right Front (#20)
1
x
Leg - Right Rear (#21)
4
x
Screw (#A)
4
x
Washer (#B)
4
x
Locking Washer (#C)
INSTALLATION:
•
Place a piece of cardboard on the floor to prevent scratching the unit. Lay the
main barrel on its side, hopper end pointed upward, on the cardboard.
•
Mount one support leg to the floor end of the main barrel using one screw,
locking washer, and washer, through the one pre-drilled hole. Repeat
installation for second support leg. Note Illustration 1A.
•
Mount one support leg for caster to the hopper end of the main barrel using
one screw, locking washer, and washer, through the one pre-drilled hole.
Repeat Installation for second support leg for caster. Note illustration 1B.
NOTE: FASTEN SCREWS OF THE SUPPORT LEGS ONLY HALF-WAY TO ALLOW
EASIER INSTALLATION OF BOTTOM SHELF IN NEXT STEP.
ASSEMBLY INSTRUCTIONS
IMPORTANT: IT IS ADVISED TO READ EACH STEP ENTIRELY BEFORE STARTING ASSEMBLY ON INSTRUCTIONS. DO
NOT TIGHTEN SCREWS COMPLETELY UNTIL ALL SCREWS FOR THAT STEP HAVE BEEN INSTALLED. HARDWARE
COMBINATION INVOLVING A LOCKING WASHER AND WASHER SHOULD BE INSTALLED WITH THE LOCKING
WASHER CLOSEST TO THE HEAD OF THE SCREW.
GETTING S
TAR
TED