Jazz S50
2022-03
Installation and adjustment
12
EN
NL
4.4 Adjust the brakes
Risk of injury – Brakes may only be adjusted by your specialist dealer.
1. Install the wheels according to § 2.6.
2. Disconnect the brakes by pulling lever (1) backwards
(Fig A).
3. Loosen bolt (2) so the brake mechanism can slide over the frame (3)
(Fig B).
4. Pull the brake mechanism over the frame (3) to the desired position
(Fig B).
The adjustment
of the brakes shall be in the range of the marked dashes (4) on the brake mechanism.
5. Retighten the bolt (2)
(Fig B).
6. Check working of the brakes.
7. If necessary repeat the above steps until the brakes are adjusted well.
4.5 Pneumatic tyre changing
Risk
of injury and/or damage
If handled improperly, the rim might be damaged. Rather let an expert perform these activities.
When mounting a tyre, make sure no objects or body parts are pinched between the tyre and
the rim.
When inflating the tyres, always check that the pressure is correct. The correct pressure is
given on the tyre walls.
Use only inflating equipment which complies with regulations and indicates the pressure in bar,
or use the supplied air pump. We do not accept any liability for damage caused by inflating
equipment not supplied by the manufacturer.
Always make sure that the wheels are sufficiently inflated, since it could affect the
driving behaviour.
We do not accept any liability for wheels not supplied by the manufacturer.
Only an expert can guarantee correct assembly. Work not done by your specialist
dealer, would void the warranty of claims.
If you want to change the tyres or inner tubes, you should note the following:
1. Let all the air out of the inner tube.
2. Insert a tyre lever between the tyre and the rim.
3. Slowly and gently push the tyre lever downwards. This will pull the tyre over the edge of the
rim.
4. Then move the lever along the rim, the tyre will jump out.
5. Now carefully remove the tyre from the rim and then remove the tube.
Before replacing the tyre, check the rim bed and the inside wall of the tyre for foreign matter and
clean these properly if necessary. Check the condition of the rim bed, especially around the
position of the air valve.
A
B
WARNING
CAUTION
