Jazz S50
2022-03
Before use
6
EN
NL
Figure 1
Figure 2
Steps to secure the wheelchair user:
1. Remove both arm rests.
2. If present, attach the wheelchair's pelvic belt.
3. Attach the occupant restraint belts according to the instructions of the strap-system
manufacturer.
4. Wear the pelvic belt low across the front of the pelvis, so that the angle of the pelvic belt is
within the preferred zone of 30° to 75° to the horizontal, similar to that shown below.
5. A steeper (greater) angle within the preferred zone is desirable.
6. Adjust the belt tightly according to the instructions of the strap-system manufacturer,
consistent with the user's comfort.
7. Ensure that the restraint belt connects in a straight line to the anchor point in the vehicle and
that no bends in the belt are visible, for instance at the axle of the rear wheel.
8. Install the arm rests, if desired. make sure that belts are not twisted or held away from the
body by wheelchair components such as arm rests or wheels.
PELVIC RESTRAINTS SHOULD MAKE FULL
CONTACT ACROSS THE FRONT OF THE BODY
NEAR THE JUNCTION OF THE THIGH AND
PELVIS
RESTRAINTS SHOULD NOT BE HELD
AWAY FROM BODY BY WHEELCHAIR
COMPONENTS SUCH AS ARMRESTS OR
WHEELS
