STAGEMAKER®
-
24
VERLINDE reserves the right to alter or amend the above information without notice.
11/2008
6.21 Description of the Gear limit switch (stepless)
It is located into the brake cover and is adjusted in our works.
This device limits the path of the hook.
The setting is done as follow (after load chain replacement for example) :
1- Take off the cap of the upper part of the hoist
2- Remove the guiding bar (1)
3- For upper limit switch :
Move the adjustment disc (4) (on the bottom side of the hoist)
4- For lower limit switch :
Move the adjustment disc (3)
5- Put the guiding bar (1) back into the corresponding holes of the discs.
6- Check that the limit switches stop the direction at the desired positions
If they don’t, restart the adjustment from point 2.
7- Check that the hook or buffer doesn’t touch the casing when stopping at high speed.
8- Put back the cap.
Note : Due to the deceleration ramp of the stepless speed control, the stopping position in high or low
speed may vary.
