STAGEMAKER®
-
36
VERLINDE reserves the right to alter or amend the above information without notice.
11/2008
To adjust the slipping clutch, it is recommended to use the chain
force measuring device. Nevertheless, it is possible to use loads.
10.3.3 Adjustment of the brake
•
Before starting the adjustment, remove the load and switch off the power supply.
•
Remove the brake endcap and the sealing.
•
Use feeler gauge to measure the air gap (
X
) between the brake disk (2) and the electromagnet at
at least three points around the electromagnet.
•
To ajust the brake :
- Unscrew one of the locking screw (5).
- Adjust the air gap by turning the adjusting screw (6) counterclockwise to reduce the airgap,
clockwise to increase it.
- Tightens the locking screw (5).
- Make the same operation with the 2 other adjustment points.
- Control the air gap adjustment all around the magnet.
•
Check the operation of the brake
•
Fit the sealing and the brake endcap
Brake air gap
Minimum air gap (mm)
Maximum air gap (mm)
Between brake disk (2) and coil (1)
X = 0.20
X = 0.50
)
To replace the brake/slipping clutch assembly, the electromagnet supply wires inside the
electric box must first of all be disconnected.
10.4 Thickness of brake lining
Thickness as new
Replace when
9,4 mm
8,4 mm
10.5 Chain
10.5.1 Removal of the chain
1-fall chain :
•
Remove the load from the hook.
•
Disassemble the hook block.
MEASURE
FRICTION MATERIAL
BRAKE ASSEMBLY
