Verint NEXTIVA S2800E series, Руководство пользователя

Страница: 24 / 71

2: Installing and Configuring the S2800e
Verint Video Intelligence Solutions 16
2. Swing up the interface board to latch it into place. If the interface board was completely
removed, reinstall it correctly with the white connector near the wall of the enclosure.
3. Dress the cables up over the board to ensure that there is no excess cable hanging past
the board.
4. Connect the safety cord clip of the enclosure to the tab in the camera drive. Allow the
drive to hang from the enclosure.
5. Insert the safety cord clip of the lower dome into the hole in the enclosure.
6. Align the two slots on the camera drive with the tabs in the enclosure, being sure to
match up the arrows on both the drive and in the enclosure. Insert the camera drive
into the enclosure until it snaps into place.
7. Line up the two molded tabs on the lower dome with the two recesses on the inner
enclosure. There are only two ways to align it.
8. Push the lower dome up into the camera. Verify that it snaps into place on both sides.
The upper edge of the lower dome should be flush with the ceiling plane.
Nextiva S2800e Series User Guide.book Page 16 Wednesday, March 11, 2009 3:20 PM