2: Configuring and Installing the Device
14
Verint Video Solutions
With SConfigurator, you activate the alarm process by checking the Forward I/O box in the
Connection Creator window.
Updating the Firmware
You can update the firmware of the S1900e devices with the SConfigurator utility or a video
management software; for the detailed procedure, refer to the documentation of the
software. The latest firmware files are available on the Verint Video Solutions extranet
(Technical Support, then Downloads, then Firmware Upgrades).
Warning: Firmware downgrade is not supported on any device. If you perform a
downgrade, any problem encountered will not be covered by your product
warranty.
The only method to update the firmware is through an IP network connection. If this update
procedure fails:
1.
Restart the same procedure immediately.
2.
If the problem persists, move the device so that it is in the same IP subnet as the host
computer, then restart the procedure.
You should take into consideration the following facts regarding firmware update using the
IP network:
It can be deactivated in the command line interface (CLI) or the web interface.
Ensure that the IP link is stable before starting the procedure; therefore it is not
recommended to perform it over the Internet.
Performing a Hardware Reset
You can perform two types of hardware reset on the S1900e device:
A hard reset that will assign the factory default settings to the device (listed in
Appendix A on page 41). All user-defined values will be lost. Following such a reset, you
will need to reprogram the device (for instance, its IP address and VSIP port) for proper
operation within its network.
A soft reset during which the device will retain its configuration.
To perform a hard reset:
1.
Press and hold the Reset button, until the system status LED flashes red very rapidly (it
can take up to 10 seconds).
2.
Hold the button for an additional five seconds, until the LED turns off.
The device is ready for use with the factory default settings.
To perform a soft reset:
Press and hold the Reset button one second.
The device reboots, while retaining its configuration.
Содержание Nextiva S1900e Series
