3
Align the wall mount and screws with the
holes in the wall as shown. Tighten the screw
in the middle hole first, so that the wall mount
position is fixed. You can tighten the other
screw in the top hole.
4
Place the baby unit on the wall mount.
Tighten the screw into the threaded socket at
the bottom to secure the baby unit.
5
Plug the power adapter into the baby unit,
plug the other end of the power adapter into
the wall outlet. Bundle the power cord neatly
with the self-adhesive strap. Make sure to
keep the power adapter cord away from
children’s reach.
BM3510 Baby Unit
Quick Start Guide
(for use with BM3500 parent unit)
1
NOTE
Check for reception strength and camera angle
before drilling the holes.
Place the wall mount on a wall, and then
use a pencil to mark the top two holes as
shown. Remove the wall mount and drill two
holes in the wall (7/32” drill bit).
2
If you drill the holes into a stud, go to step 3.
-OR-
If you drill the holes into an object other than
a stud, insert the wall anchors into the holes.
Tap gently on the ends with a hammer until
the wall anchors are flush with the wall.
1
2
3
VOL
ON/OFF
Mount the baby monitor
VOL
ON/OFF
Power outlet
Self-adhesive
trap
