Verint Nextiva S1900e Series, Руководство пользователя

Страница: 19 / 79

Verint Video Solutions 9
Nextiva S1900e Series User Guide
Performing a Point-to-Point Connection
c
To view video on a monitor in a point-to-point context (as opposed to using a video
management software), you have to create a fixed connection between an S1900e
transmitter and an S1970e receiver. Typically, both devices sit on the same IP subnet as
SConfigurator and have the same VSIP port; to access other devices, refer to the device
discovery section in the
SConfigurator User Guide .
For more information about the connection procedure or the video modes, refer to the
“Managing Connections” chapter, in the
SConfigurator User Guide .
To perform a point-to-point connection:
1. Start SConfigurator.
2. In the Units tab, discover the desired devices.
The discovered devices appear in the Units box.
3. Select the Connections tab, then click Add .
The Connection Creator window appears.
4. Select a transmitter in the left column and a receiver in the right one.
In the Transmitters column, you have access to the two encoders of each input; the
video stream is the same for both. Stream1 is typically reserved for web viewing,
therefore you should use Stream2 for point-to-point connections.
5. In the Video list, select the desired video mode.
6. To disable I/O data transmission (for example, alarms) between the two selected
devices, clear
Forward I/O .
7. To disable serial port data transmission (like PTZ commands), clear Forward Serial
Port Data .
8. To enable audio between the devices, ensure that Enable Audio is checked, then select
the audio mode.
9. Click Connect .
You should now have video on the monitor connected to the receiver.
c