Verine VLF45NG, Инструкции по установке, использованию и обслуживанию

Страница: 6 / 20

6
8 Cut and form a section of 8mm pipe, only rigid or semi-rigid tube is acceptable, and
run this into the fireplace opening. If a concealed fitting is required, care must be
taken to sleeve the supply pipe when passing it through masonry. Exposed pipe
within the fire opening should be wrapped, painted with bituminous paint, or be
factory sheathed.
9 Seal the firebox into the fire opening using the sealing tape provided or a water
based mastic.
10 Fit the burner unit into its mounting brackets within the firebox.
11 Prior to connecting the burner to the gas supply, it is advisable to blow out the pipe
to clear any dirt that may be present and which could cause a blockage in the control
valve or pilot.
12 Using the nut and olive provided, connect the 8mm supply pipe to the combined
pressure test point and isolator fitting.
13 Complete the installation of the appliance as above.
ADDITIONAL NOTES FOR HANDSET REMOTE CONTROL MODEL
1 The installation of the appliance should be carried out following the procedures as
per the section entitled “Fitting the Appliance” on page 4.
2 After installing the burner, positions must be found for the battery pack and the Infra
Red (IF) signal receiver. The fret and ash pan cover will have to be put in position to
find the best place for these items.
3 Battery
Place the battery pack on the hearth along the front of the fire just behind the ash
pan cover.
DO NOT PLACE THE BATTERY PACK UNDER THE FIRE.
4 Plug the small jack plug from the charger into its socket at the end of the battery
pack and plug the charger into the mains and switch on to give the batteries a top up
charge.
FIGURE 2