Verine VLF45NG, Инструкции по установке, использованию и обслуживанию, Страница: 13 / 20

13
Remote Appliances
9 Using the handset
When using the handset make sure that it is
pointed at the infra red signal receiver
located under the front of the fire (the small
black pad). Unlike a TV control the fire does
not react to a quick press on the button on
the handset control. The buttons must be
pressed and held until the control box under
the fire acknowledges the signal by emitting
a 'beep' sound (this can take two or three
seconds) and then released. When the
handset is emitting a signal the yellow LED
at the top of the control will flash.
10 Lighting the Fire See Figure 9
To light the fire press the OFF and the
STAND BY buttons together on the handset
until the fire control box answers with a
'beep' and then released. The fire will go
through its start - up procedure by lighting
first the pilot burner and then the main
burner on high fire. This procedure takes
about 30 seconds. If the fire does not light or
there is no reaction when the two buttons are pressed, press the OFF button to re-
set the control and try again.
11 Adjusting the Flame Height
To turn the fire from high to low, press and release the low fire button as soon as the
'beep' is heard and the flame height will reduce. If the fire is set at high and a flame
height between high and low fire is desired, press and continue to hold the low fire
button after the 'beep' has sounded. The flame height will gradually decrease.
Release the button when the desired height of flame is achieved. To turn the fire
from low fire to high fire press and (after the 'beep' is sounded) release the high fire
button. To gradually increase the flame press and hold the button as described
above for the low fire button.
12 Turning the Fire OFF
To turn the fire off but leave the pilot burner alight press the STAND-BY button until
the 'beep' is heard. Use this facility to conserve battery life if the fire is going to be
used again later in the day. To turn the fire completely off press the OFF button. The
STAND-BY button and the OFF button can be pressed when the flame is at any
height. To light the main burner from the STAND-BY position press either the HIGH
FIRE or LOW FIRE buttons.
13 Manual OFF Facility
If, whilst the fire is alight, the handset control is lost or its battery becomes
discharged the fire can be turned off by pressing and holding the manual off button
situated on the fascia underneath the front of the burner. This button disconnects the
battery from the control box and the fire will go out after the button has been held in
for about a minute. Care should be taken as the fret / ash pan cover as well the
burner facia will be hot.
Figure 11 FIGURE 9