Verilink KIRK Wireless Server 6000, Руководство пользователя

Страница: 295 / 323

NetEngine IAD User Guide
Menu Map 276
P. VoicePath
Configure*
J. Set Jitter Delay
D. Display Jitter Delay
S. Set Start Mode
(Loop Start/Ground Start)
T. Set SLIC Control Mode
U. Set Compander Mode
(u-Law, A-Law)
O. Set On Hook Transmission
Mode of Ground Start Lines
L. Set Idle Voltage Mode of
Ground Start Lines
M. Set Debug Mode
E. Configure Echo Cancellation
Default Settings
G. Set Loop Gain
C. Set Country Mode
N. Configure
NAT
B. Enable/Disable NAT
Debug Messages*
P. Enable/Disable NAT
Translation by Port
T. Configure NAT
TCP Timeout
U. Configure NAT
UDP Timeout
R. Configure NAT
Port Range
N. Configure NAT Local
Server Entry
A. Configure NAT Alias Entry
S. Display NAT Statistics
C. Display NAT Connection Table
D. Display NAT Connection Details
O. Display NAT Local Server Table
E. Display NAT Alias Table
X. Delete IP Address from NAT Tables
Y. Delete NAT Local Server Entry
Z. Delete NAT Alias Entry
D. Configure
DHCP
E. Enable/Disable DHCP
H. Enable/Disable Checking for
Add'l DHCP Servers
B. Enable/Disable DHCP
Debug Messages*
I. Configure DHCP
Server Parameters
P. Configure DHCP
Address Range Pool
C. Configure DHCP
Client Entry
F. Display DHCP
Configuration
S. Display DHCP
Server Statistics
A. Display DHCP Server
Assigned Addresses
U. Display DHCP Server
Unassigned Addresses
D. Display DHCP
Entry Details
X. Delete A DHCP
Client Entry
Y. Delete A DHCP
Assignment Entry
V. Set Voice Gateway
M. Configure
Multicast
R. Reset
System
E. Enable/Disable Global
IP Multicasting
P. Config PIM-Dense Mode
by Port
S. Add/Change Multicast
Route Source
G. Show IGMP Group
Q. IGMP Querier
M. Show Multicast
Routing Table
N. Show PIM Neighbor
T. Telephony
Clock Recovery
1. Enable/Disable
Derived Timing
2. Enable/Disable
Dervied Timing
Debug Messages
Z. Diagnostics
C. Command
Line Interface
R. Reset System
=> Command
(See Chapter 13,
Command Line Interface)
P. POTS Diagnostics