NetEngine IAD User Guide
Router Configuration
104
Basic
Router
Setup
Tasks
To configure the IAD as a router, you should complete the following tasks:
u
Configure IP addresses on the LAN and WAN ports (page
106
)
u
Enable RIP poisoned reverse (recommended—page
110
), add a static
route (page
112
), or add a default route (page
113
)
u
Disable bridging globally (page
132
) or by port (page
133
)
u
Disable Spanning Tree Protocol (STP) globally (page
134
) or by port
(page
134
)
Use this flowchart to plan your tasks, based on your router configuration
requirements.
Figure 5–1. Router Configuration Task Flowchart
Main
Menu
Yes
Yes
Enable
bridging
interface
per port
End
Enable RIP
globally
All interfaces
configured
with IP?
No
No
Using default
route?
Define IP for
each interface
per port
End
End
Add default
route to
routing table
Configure
RIP version
by port
Enable
global
bridging
Add static
route to
routing table
Using
RIP?
Содержание KIRK Wireless Server 6000
