VERDER PACKO ZL Series, Руководство по эксплуатации и техническому обслуживанию

Страница: 9 / 39

7
2 SAFETY
2.1 DO’S & DON’TS
DO read and understand these instructions before installing or using the pump.
DO use PACKO spare parts when replacing a component of the pump.
DO NOT service the pump while it is running.
DO NOT place the pump in an application where the service ratings are exceeded.
DO NOT modify the pump. Modifying the pump creates unsafe conditions and voids all warranties.
DO NOT run the pump at a temperature or differential pressure higher than specified on the
pump nameplate.
SAFETY PRECAUTIONS WHEN INSTALLING THE PUMP
DO use an authorized electrician when connecting the pump.
DO observe the mechanical limits of the pump (refer to the pump performance sheet).
DO earth the base plate of the pump to avoid the potential buildup of static electricity.
DO NOT install a throttling valve in the suction line.
SAFETY PRECAUTIONS WHEN OPERATING THE PUMP
DO:
only qualified personnel should operate this pump.
DO NOT start the pump as long as someone is working on or touching the pump.
DO NOT touch the pump or the lines when pumping hot fluids or when performing Clean In Place
(CIP) procedures.
DO NOT run the pump with BOTH the suction inlet or discharge outlet blocked. Running the pump
with the inlet or outlet blocked will cause serious damage to the pump.
DO ALWAYS check the pump rotation with liquid in the pump.
DO NOT run the pump with the front cover removed. The rotors and rotor case could be damaged
or may cause severe injury.
DO NOT operate the pump with removed safety guard or shroud.
SAFETY PRECAUTIONS WHEN SERVICING THE PUMP
DO ensure the pump is cool to touch before performing service.
DO relieve all pressure and drain all fluids from the pump and connected piping before performing
service.
DO ENSURE POWER TO THE UNIT HAS BEEN UNPLUGGED PRIOR TO PERFORMING
ANY PUMP MAINTENANCE OR CLEANING.
DO exercise caution and wear protective clothing when using lye or acid for cleaning.