VERDER PACKO ZL Series, Руководство по эксплуатации и техническому обслуживанию

Страница: 24 / 39

22
6.4 ROTOR CASE ASSEMBLY
Before installing the rotor case (31) to the gearbox (1A), make sure to clean the surface of the
rotor case and the Gearbox and make sure to put the shims between rotor case and Gearbox as
originally.
Assemble the rotor case (31) onto the Gearbox (1A) and secure
the four hexa-nuts (46) with reference of below torque set
value.
Series ZL100 ZL200 ZL300
ZL400 ZL500
Nut size M8 M10 M14
M20 M20
Torque (Nm) 30 34 80 120 120
Assemble rotors onto the shaft, engaging the shallow groove
with short
spline in rotor and seal side first in to the shaft.
Place the plastic bar between the rotors as shown in Figure 24.
Tighten the first rotor bolt with a special delivered tool to the
below recommended torque.
Series ZL100 ZL200 ZL300
ZL400 ZL500
Bolt size M8 M14 M18
M18 M18
Torque (Nm) 17 35 48 56 56
To tighten the second rotor, place the plastic bar on the opposite
side of the rotor and tighten the second rotor bolt to the proper
torque.
Be sure not to make any bur on the rotor bolt groove during this process. It may cause a serious
problem such as galling on the rotor case and if it happened, it must be removed.
Install the new O-ring inside of the cover (32) and slide the
cover over the studs. Screw the cap nuts (33) on the studs and
tighten using an appropriate wrench with reference of below
torque set value in an opposing manner shown in Figure 25.
Series ZL100 ZL200 ZL300
ZL400 ZL500
Nut size M8 M10 M14
M20 M20
Torque (Nm) 14 17 30 52 52
Fig. 22
Fig. 24
Fig. 25
Fig. 23