Veratron OceanLink 4.3, Руководство пользователя

Страница: 4 / 88

SAFETY INFORMATION
A2C15587600
lamps can cause damage to control units or other
electronic systems.
•
The electrical indicator outputs and cables
connected to them must be protected from direct
contact and damage. The cables in use must have
enough insulation and electric strength and the
contact points must be safe from touch.
•
Use appropriate measures to also protect the
electrically conductive parts on the connected
consumer from direct contact. Laying metallic,
uninsulated cables and contacts is prohibited.
SAFETY AFTER INSTALLATION
•
Connect the ground cable tightly to the negative
terminal of the battery.
•
Reenter/reprogram the volatile electronic memory
values.
•
Check all functions.
•
Use only clean water to clean the components. Note
the Ingress Protection (IP) ratings (IEC 60529).
ELECTRICAL CONNECTION
•
Note cable cross-sectional area!
•
Reducing the cable cross-sectional area leads to
higher current density, which can cause the cable
cross-sectional area in question to heat up!
•
When installing electrical cables, use the provided
cable ducts and harnesses; however, do not run
cables parallel to ignition cables or to cables that lead
to large electricity consumers.
•
Fasten cables with cable ties or adhesive tape. Do not
run cables over moving parts. Do not attach cables to
the steering column!
•
Ensure that cables are not subject to tensile,
compressive or shearing forces.
•
If cables are run through drill holes, protect them
using rubber sleeves or the like.
•
Use only one cable stripper to strip the cable. Adjust
the stripper so that stranded wires are not damaged
or separated.
•
Use only a soft soldering process or commercially
available crimp connector to solder new cable
connections!
•
Make crimp connections with cable crimping pliers
only. Follow the safety instructions of the tool
manufacturer.
•
Insulate exposed stranded wires to prevent short
circuits.
•
Caution: Risk of short circuit if junctions are faulty or
cables are damaged.
•
Short circuits in the vehicle network can cause fires,
battery explosions and damages to other electronic
systems. Consequently, all power supply cable
connections must be provided with weldable
connectors and be sufficiently insulated.
•
Ensure ground connections are sound.
•
Faulty connections can cause short circuits. Only
connect cables according to the electrical wiring
diagram.
•
If operating the instrument on power supply units,
note that the power supply unit must be stabilized
and it must comply with the following standard: DIN
EN 61000, Parts 6-1 to 6-4.