1777-141202(EN)
Installation manual Sun awning V225 - Porto semi-cassette
4.1 Standard factory setting
The walk-through height of the front bar is standardly set between 1,80 and 1,90 meter at an installation height of 2,70
meter.
4.2 Setting the inclination
If you want to set the awning different from the standard factory setting, follow the steps below:
1.
Roll the awning out. The arm connections are located left and right on the awning.
2.
Twist nut #1 in one turn (wrench 17). Lift the front bar during the twist so that the adjusting bolt (or allen) moves easily.
See figure 4.1.
3.
Twist hexagon nut #2 (wrench 13) or allen #2 for an up and down movement. Left = down, right = up. Lift the front bar
during the twist.
4. If the front bar is on the right height on one side, than:
Fasten nut #1. Lift the front bar during the twist so that the allen nut #3 (allen #6) is fastened rectilinear.
The allen nut #3 can be skew is nut #1 is loosened to much.
5. Repeat the steps above on the other side until the front bar is in the same line with the top cap.
Attention!
Never touch nut #4.
4
1
2
3
fig. 4.1 Detail arm connection right
8
4. Inclination
www.samsondoors.co.uk
0800 328 6250
www.samsondoors.co.uk
www.samsondoors.co.uk
0800 328 6250
www.samsondoors.co.uk
