1777-141202(EN)
Installation manual Sun awning V225 - Porto semi-cassette
1.4 Installation using wall strips
If there are less than five rows of stones above the installation location, wall strips need to be used. The strips divide the
power over a larger wall surface so that the wall can carry more weight. figure 1.3.
Follow the steps below to install the wall strips (see figure 1.3 and 1.4):
1.
Mark the positon of the wall strips on the wall according to size X and Y in figure 1.2. The wall strips need to be, both
horizontal and vertical, levelled. Make sure that the installation holes are in the middle of the stone. If necessary, use
an alignment string.
Attention! The left wall strip is turned 180 degrees relative to the right wall strip.
Fasten the wall strips tight to the wall.
2. Install the awning as high as possible on the wall strips with two nuts per wall support.
3. Install the fastening block at the bottom of the wall strip. The block is needed to fasten the cover plate.
4.
Place the closure cap over the bottom part of the wall strip. You need to customize it first.
5. Install the cover plate to the fastening block in the bottom part of the wall strip.
6.
The installation of the awning on the wall strips is now finished.
LINKS
RECHTS
boorsleuf
fig. 1.3 Using wall strips
5
5
3
2
1
6
4
fig. 1.4 Installation of the wall strip (left)
LEFT
Drill slot
RIGHT
www.samsondoors.co.uk
0800 328 6250
www.samsondoors.co.uk
www.samsondoors.co.uk
0800 328 6250
www.samsondoors.co.uk
