1777-141202(EN)
Installation manual Sun awning V225 - Porto semi-cassette
6
2. Electrical wall control
TIP! Sealing the hole
In case of an electrical wire to the inside, we advise to seal the hole where the wire comes in. This to prevent moisture from
running inwards. Attention! Do this both on the in- and outside.
2.2 Standard factory setting
The motor control is set standardly.
See the included manual of the motor and the possible remote control.
fig. 2.1 Motor left (seen from the outside)
fig. 2.2 Motor right (seen from the outside)
2.1 Connecting the wall control
1.
Check the position of the motor (left or right), seen from the outside!
2.
If you have inside control, first guide the cable through the hole in the wall you drilled before.
3. Connect the four-wired cord of the motor and the three-wired cored with plug following the scheme below.
4. Put the plug in the power point.
5.
The awning is now connected. Before you continue the installation, check if the awning rolls out correctly.
geel/groen
blauw
bruin
geel/groen
blauw
zwar
t
bruin
bruin
geel/groen
blauw
bruin
geel/groen
blauw
zwar
t
bruin
bruin
geel/groen
blauw
bruin
geel/groen
blauw
zwar
t
bruin
bruin
geel/groen
blauw
bruin
geel/groen
blauw
zwar
t
bruin
bruin
br
own
br
own
br
own
br
own
br
own
br
own
black
black
blue
blue
blue
blue
yello
w
/gr
een
yello
w
/gr
een
yello
w
/gr
een
yello
w
/gr
een
www.samsondoors.co.uk
0800 328 6250
www.samsondoors.co.uk
www.samsondoors.co.uk
0800 328 6250
www.samsondoors.co.uk
