E - 2
walked on or pinched particularly at
the power, convenience receptacles,
and the point where they exit from
the apparatus.
11. Only use attachments/accessories
s p e c i f i e d b y t h e
manufacturer.
12. Use only with the cart,
stand, tripod, bracket, or
table specified by the manufacturer, or
sold with the apparatus. When a cart
is used, use caution when moving the
cart/apparatus combination to avoid
injury from tip-over.
13. Unplug this apparatus during lightning
storms or when unused for long
periods of time.
14. Refer all servicing to qualified service
personnel. Servicing is required when
the apparatus has been damaged in
any way, such as the AC power cord is
damaged, liquid has spilled or objects
have fallen into the apparatus, the
apparatus has been exposed to rain or
moisture, does not operate normally,
or has been dropped.
WARNING:
Should any problems occur, disconnect the Car power adapter and refer
servicing to a qualified technician.
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings.
Install in accordance with the
manufacturer’s instructions.
8. Do not install near any heat sources
such as radiators, heat registers,
stoves, or other apparatus (including
amplifiers) that produce heat.
9. Do not defeat the safety purpose of the
polarized or grounding-type power. A
polarized power has two blades with
one wider than the other. A grounding
type power has two blades and a third
grounding prong. The wide blade or
the third prong is provided for your
safety. When the provided power cord
does not fit into your AC power outlet,
consult an electrician for replacement
of the obsolete outlet.
10. Protect the AC power cord from being
IMPORTANT SAFETy PRECAUTIONS
• When you are not going to use the unit for a long period of time, disconnect the Car power
adapter.
CONDENSATION INFORMATION
When left in a heated room where it is warm and damp, water droplets or condensation may form
inside the unit. When there is condensation inside the unit, the unit may not function normally.
Let the unit stand for 1-2 hours before turning the power on or gradually heat the room and
allow the unit to dry before use.
FCC INFORMATION
WARNING:
Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment, when used
in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an aC power outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/tV technician for help.
811-798191W012.indd 2
4/1/2008 5:00:57 PM
