ТSТ 1-300 series Touch Screen Room Thermostat, with multi, updated
and computerized functions, detects different temp between ambient and
setting temperature using precise NTC sensor(internal only) to adjust
Heating and Cooling.
Hence, it keeps the room at comfortable and constant temp.
It could be programmable and non-programmable
1.General
ТSТ 1-300 Series Touch Screen Room Thermostat
2.Technical data
2-1. Power Supply: 220/110/24VAC(optional) ± 10%, 50/60Hz
2-2. Consumption: <1.5W
2-3. Load Current: 1A(0.6A)
0
2-4. Accuracy: ±1 C
0
0
2-5. Set-point Range: 10.0 C - 30.0 C
2-6. Timing Error: <1%
2-8. Output Consumption: <200 W
3. Warning
WARNING:
RISK OF ELECTRICAL SHOCK.
Disconnect power supply before making electrical connection.
Contact with components carrying hazardous voltage can
cause electrical shock and may result in severe personal
injury or death.
4. Wiring
(
p
lease contact us for other wirings)
LCD Motherboard
Drive Board
Low
Med
High
Fan
Valve
Valve Closed
Valve Open
5. Symbols
Power on/off.
Mode: press 0.3 seconds --- Heating/Cooling/Air flow only
Menu: Press 3 seconds---- Sleeping; Non-programmable &
Programmable switchover; time and Programmable setting
Fan Speed: auto, high, middle and low
Temperature setting and mode adjusting.
6. Menu & Setting
Programmable(optional) - Please refer to Non-programmable(manual):
6-1. Temperature setting.
A. Programmable : When it is running, temperature
and Power on/off can not be adjusted.
Please refer to 6-6.
B. Non-programmable(Manual): Can set it directly
through when in standby mode.
(LCD screen shows “ ” on the top right corner)
6-2.Fan speed setting
Fan speed: AutoHighMedLow
Under auto fan mode, thermostat could adjust fan
speed automatically according to comparing diff.
Temp. between room and set point.
6-3.Heating/Cooling/Air Flow Setting
Touch mode key: Heating/Cooling/Air Flow
changeover. When it is Air Flow, valve closes,
and fan coil supplies air.
6-4.Sleeping Setting
Touch Function key for 3 seconds to switch
to Sleeping and when the " “ is flickering,
please press for confirm and for cancel.
6-5.Programable& Non-programmable switchover
Touch Function key for 3 seconds to switch to
Non-programmable (manual).
When the “ ” is flickering, please touch for confirm
and for cancel.
6-6.Programmable Setting (optional)
The steps of setting for one week are 18 ( from 1 to 18, please refer to
following instruction and chart), press for 3 seconds and then
operate as following: Minute setting of Clock --- Hour setting of Clock----
Week setting --- Minute setting of turn-on (first time zone) --- Hour setting
of turn-off (second time zone) --- Hour setting of turn-off zone) ---
Temp.setting
Mon.-Fri.
Sat.
Sun.
Time
Temp
T
ime
zone
Т
S
Т 1-300 -А
Т
S
Т 1-300 -В
Т
S
Т 1-300 -С
LCD Motherboard
Drive Board
LCD Motherboard
Drive Board
Valve
Valve
Fan
Low
Med
High
Valve Closed
Valve Open
Time
Temp
Time
Temp
