This product is fitted with a replaceable battery in the controls. To replace the battery, follow
the steps below, shown in
Fig. 5
:
1. Unhinge the heater from the wall using the clips shown in
Fig. 2
and locate the battery
module
2. Slide the catch and pull module from the controls.
3. Remove the coin cell battery and replace.
4. Slide module back in place, ensuring clip is engaged.
During the initial operation, some odour may be noticed due to the newness of materials used in
manufacture. This is normal and will disappear after a short period of use. It is however advisable
to keep the room well ventilated.
Cleaning
WARNING - ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE
CLEANING THE HEATER.
Before commencing cleaning, isolate the heater from the electrical supply and allow it to cool.
The outside can be cleaned by wiping it over with a soft damp cloth and then dried. Do not use
abrasive cleaning powders or furniture polish, as this can damage the surface finish. To release
the heater from the wall bracket for cleaning or redecoration, depress the latch on both brackets
(See
Fig. 2
) and hinge forward.
IMPORTANT: Before replacing the battery ensure the heater is isolated from the electricity
supply. NOTE - Battery should be disposed of in an appropriate manner
2
1
3
4
5
Battery positive side up
Fig. 5
Battery Replacement
Important
25
