1. Lay the back side of the hood flat on a table. Use a piece of cardboard
to avoid damaging the table or the hood.
2. Remove the grease filters by pulling down the metal latch tab and
tilting filters downward to remove.
3. Align the hood and center it above the hood mounting bracket.
Gently lower the hood until it securely engages the bracket.
4. With the hood hanging in place, drill through the both holes located in
the inside lower back of hood (
Fig. 1
) using a
5
⁄
16
” dril bit. Insert the
included drywall anchors into the drilled holes (one for each hole). Install
(2) washers and (2) #8 x 1¼” mounting screws into the drywall anchors.
Verify that the hood is centered and leveled. Tighten all screws completely.
5. Reinstall grease filters by aligning rear filter tabs with slots in the hood.
Pull down the metal latch tab, push filter into position and release.
Make sure filters are securely engaged after installation.
6. Slide a 6” steel round duct over the duct collar (
Fig. 2
). Then, use
duct tape to seal the joint.
7. Plug hood power cord into the outlet.
8. Remove the upper flue from inside the lower flue. Install the lower flue
bracket to the lower flue using (2) flue bracket screws #8 x
7
⁄
16
”, make
sure that the slots point up (
Fig. 3
). Carefully place back the upper flue
inside the lower flue. Remove protective plastic film covering the lower
flue only.
9. Carefully place both flues into the recessed area of hood top.
10. Slide up the upper flue until it is aligned with its upper flue mounting
bracket. The bracket should be inside the flue. Secure the upper flue on
the upper flue mounting bracket using (2) #8 x
7
⁄
16
” mounting screws. (
Fig. 4
)
11. Remove protective plastic film covering the upper flue and the hood.
12. Mount the glass plate or the stainless steel plate on the top of hood base with
(4) mechanical flat head screws (M4 x 0.7”) and (4) aesthetic washers. Screw
from top of hood base.
7. INSTALL THE HOOD
CAUTION
DOT NOT REMOVE the protective plastic film covering the decorative flue (upper & lower) and the hood yet.
-6-
Fig. 1
Fig. 2
Fig. 4
6” ROUND
DUCT
UPPER
FLUE
UPPER FLUE MOUNTING BRACKET
WARNING
BE CAREFUL when installing the decorative flue and hood, they may have sharp edges.
!
Fig. 3
LOWER FLUE MOUNTING BRACKET
LOWER
FLUE
INSIDE BACK
OF HOOD
