V E N G E A N C E M O T O R C Y C L E S O W N E R S M A N U A L
- 40 -
Vengeance Motorcycles, Mira Loma, CA USA • 866-483-6432 • www.VengeanceMotorcycles.com
© 2003 Vengeance Performance Products, LLC All Rights Reserved • VOM 1st Edition Rev 2.3 06/03
FUEL ENRICHENER CONTROLS
The fuel enrichener lever is located on the air cleaner backing plate, which is located underneath the right side of the
fuel tank. Pull up on the fuel enrichener lever to place it in the ON position for cold engine starts.
After the engine has warmed up, press down on the fuel enrichener lever to place it in the OFF position. Do not leave
the fuel enrichener lever in the ON position after the engine has warmed up or when starting a warm engine.
Please refer to the section on hot and cold starting your motorcycle.
CAUTION: MAKE SURE THE GASOLINE SUPPLY VALVE IS TURNED OFF WHEN THE ENGINE IS NOT
RUNNING. IF THE VALVE IS LEFT IN ANY OTHER POSITIONS, IT MAY ALLOW FUEL TO OVERFILL THE
CARBURETOR AND LEAK INTO THE ENGINE, CAUSING ENGINE DAMAGE.
CAUTION: NEVER ALLOW ENGINE TO IDLE, WHILE MOTORCYCLE IS STANDING STILL FOR MORE THAN A
FEW MINUTES BECAUSE OVERHEATING AND ENGINE DAMAGE MAY OCCUR.
FUEL CAPS
The fuel tank is fitted with its own gas cap. Take care not to cross gas cap threads during reattachment. To remove
the gas cap, turn the cap counterclockwise. To secure the cap, turn it clockwise.
CAUTION: GASOLINE WITH FUEL ADDITIVES MAY CAUSE DAMAGE TO VEHICLE PARTS. GASOLINE
SPILLS CAN DISCOLOR VEHICLE PAINT AND FINISHES. CLEAN ALL AFFECTED SURFACES IMMEDIATELY.
WARNING
USE CAUTION WHEN REMOVING FUEL CAPS. TO MINIMIZE THE CHANCE OF FUEL SPILLS, KEEP THE
MOTORCYCLE LEVEL AND REMOVE THE FUEL CAP SLOWLY, ALLOWING ANY BUILT UP PRESSURE
TO ESCAPE. CLEAN UP ANY FUEL THAT MAY HAVE SPILLED IMMEDIATELY. IF GASOLINE IS NOT
CLEANED UP IMMEDIATELY, IT MAY DAMAGE THE PAINT FINISH ON YOUR MOTORCYCLE.