VENCE TUDO SA 7300, Руководство по эксплуатации

Страница: 55 / 59

55
SA - HIDRÁULICA Super Série
Covering Discs
Check every 300 hours of work that there is slack in the bearings of the covering discs, if
so, do the required maintenance.
Store the seeder in a sheltered and safe place.
Maintain the seeder properly leaning and avoid contact of their discs and furrowers directly
with the soil.
Depth Gauge and Press Wheels
Check every 200 hours the distance of clearance of the bearings, if occur, proceed with the
necessary maintenances.
Store the seeder in sheltered place and safe.
Maintain the seeder properly leaning and avoid contact of their discs and furrowers directly
with the soil.
Opener Knife
Check and verify the points of opener knives. In any case, of excessive wear, replace them.
Double Discs and Cutting Discs
Every 500 hours of planting or a crop, accomplish the maintenance of the double discs,
bearings and ball bearings, as follows:
- Remove the external cap, loosening the adjusting screws.
- Wash the hub and remove the old grease.
- Check if there is spaces in the ball bearings, in such case adjust them.
- Replace the worn pieces that can affect the operation.
- Put new grease in the hubs and in the internal part of the cap, setting up them again.
- Every 200 working hours, verify the existing spaces in the bearings and ball bearings.
IMPORTANT
During the assembly, make the adjustment of the ball bearings so that the group
of discs rotates freely.
IMPORTANT
Use original VENCE TUDO parts only. Using the improvised parts, will cause mis -
characterize the product, avoiding the guarantee analysis of the equipment, this way.
Do not use burned oil or diesel oil for the cleaning or lubricating of the seeder.
Inspect the seeder checking if there are worn or broken parts, in case of the
existence of them and if necessary, replace the defective parts.
When the seeder is idle use the time to make the due repairs on it.
Use vegetable oil for the total protection of the seeder. In case the use of vegetable
oil is not possible, diesel oil, hydraulic or lubricant can be used only in the internal parts of
the seeder and protection of the rubberized parts and distributing discs will be necessary.