VENCE TUDO SA 7300, Руководство по эксплуатации

Страница: 37 / 59

37
SA - HIDRÁULICA Super Série
fig. 20
fig. 19
Fertilizer Distribution System
SELF CLEANING FERTILIZER DISTRIBUTION
The adjusting levers (A) (fig. 19),
exchange of drive (B) and driven spro-
ckets (C) perform the setting of amount the
fertilizer in kg/ha and the fertilizer is carry
out the rotor (G) (fig. 20).
Move regulating levers the proper
position according to the specification table
and verification of the correct number of
teeth of the drive and driven sprockets so
it is obtained the desired fertilizer amount.
Make changes to get the flow desired.
Adjust the transmission relation by means
of change the additional sprockets that come to the
machine.
LIST OF SPROCKETS THAT COME TO THE MACHINE
HEXAGONAL: Z-14, Z-24, Z-38, Z-43
SQUARE: Z-16, Z-19, Z-21, Z-24, Z-28, Z-29, Z-32, Z-38
CALIBRATION OF THE FERTILIZER REGULATORS
1- First, check if the regulators (E) (fig. 20) are free, if not, loosening the fixing bolts (F).
2- Put the adjusting lever (A) (fig. 19) in the neutral position from scale (D).
3- With one hand press the regulator and with the other secure it by means of the screw (F), so
that all regulators have the same height in relation to the rotor.
4- Make this operation in all lines; those are equipped with endless drivers.
5- Put the lever in zero position from scale (D).
6 - When all the regulators are calibrated, move the lever to the position with the desired flow. These
are figured on the setting tables.
7- Make sure the flow obtained is actually desired, if not, do this calibration again. Change the
transmission ratio through exchange the transmission sprockets.