VEMCO - VR2Tx Manual
15 March
2019
31
5
Maintenance
5.1
Battery Replacement
Replacing a battery in the VR2Tx requires four basic steps:
1.
Opening the case (section 2.1)
2.
Removing the battery
3.
Inserting the battery (section 2.2)
4.
Closing the case (section 2.3)
Most of these topics were covered when we first setup the receiver. The only remaining topic to cover is how
to disconnect and remove the battery.
5.1.1
Disconnecting and Removing Battery
STEP 2
Open the case as explained in section 2.1 and set
the Outer Cylinder aside.
STEP 1
Press the release lever on the battery connector
and pull the connector apart. The connector is small
and a small flat screw driver may be helpful.
Remove the O-ring from
around the end of the battery
section of the receiver.
STEP 3
Slide the pin along its long axis until
it exits the receiver case.
TIP:
Apply pressure (see arrow) on
the battery end while pushing pin
forwards.
STEP 4
Slide battery out of case and
dispose of it according to local
regulations.
STEP 5
