SPBS4
VELLEMAN
5
1.
control unit
2.
detection unit
3.
red wire +12VDC
4.
black wire -12VDC
For the power connection, please refer to the detailed instructions in "
Connection
" (see below).
Use the double-sided adhesive tape to fix the control unit and the warning unit securely. Please read "
Mounting
Location
" (see above) to determine where to mount the units.
Perform the reversing test (see "
Final Tests
" below).
6.4. Tips for Sensor Installation (fig. 10, 11 and 12)
Install the sensors inside the bumper. This protects the sensors from interference and enables them to work perfectly
under bad weather conditions.
Different vehicles have different widths so choose the right location to mount the sensors. Take care to install the
sensors with the head pointing in a horizontal direction. All sensors must be installed at the same height and at least
50cm above the ground (see fig. 10 below). Make sure the sensor is installed in a spot where no part of the vehicle
itself will be detected (see fig. 11 below).
Drill holes in the bumper and insert the sensors with the "UP" arrow pointing upwards. Make sure the central axis of
the sensor is perpendicular to the bumper surface.
Horizontal and vertical positioning: see fig. 12 below.
1.
bumper
