HAM06WS
18.04.2017
©
Velleman nv
10
Remarks:
o
The alarm station only remembers the last added wireless sensor added to a zone! This means that per
zone, only one wireless PIR sensor can be used.
o
The red LED will blink when the battery is almost drained (<7V).
o
Do not install the sensor onto a metal support or plate.
o
Keep the sensor away from direct sunlight and temperature variations (air conditioner, heating...).
10.
Door or window Sensor
Install the 2 sensors as illustrated on page
2
of this manual.
•
Make sure to align the triangles on both sensors and to keep the spacing between them less than 5mm.
•
Open the battery compartment and install the included 12V battery. Assign the sensor with a unique address
with the DIP switches. Close the sensor and program it into the central unit. The red LED on the sensor will
light at each door opening.
Remark: The transmitter will emit a sound when opening the battery compartment
11.
Technical specifications
Central Unit
Power Supply
12VDC (incl.)
Standby Power
12VDC (incl.)
Working Frequency
433Mhz
Remote Control Range
± 30m
Static Current
150mA
Alarm Volume
> 90dB
PIR Sensor
Detection Angle
110°
Detection Distance
max. 12m
Power Supply
9VDC (order code
6LR61
, not incl.)
Static Current
30μA
4-Key Remote Control
Power Supply
3VDC (order code
CR2032
button cell, incl.)
Panic Button
Power Supply
12VDC (order code
GP23GA
, incl.)
Door Contact
Power Supply
12VDC (order code
GP23GA
, incl.)
Siren
Power Supply
12VDC
Current
< 800mA
Use this device with original accessories only. Velleman nv cannot be held responsible in the event
of damage or injury resulted from (incorrect) use of this device.
The information in this manual is subject to change without prior notice.
©
COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv.
All worldwide rights reserved.
No part of this manual or may be copied, reproduced, translated or reduced to any electronic medium or otherwise without
the prior written consent of the copyright holder.
