DVM852
V. 01
–
29/03/2016
69
©Velleman nv
4.
Jeżeli mierzona rezystancja jest częścią obwodu, przed przyłożeniem
sond pomiarowych należy odłączyć zasilanie i rozładować wszystkie
kondensatory.
13.
Testowanie diod
Nie dokonywać pomiaru parametrów diod ani ciągłości w obwodach
znajdujących się pod napięciem. Upewnić się, że wszystkie
kondensatory w obwodzie zostały rozładowane.
1.
Podłączyć czerwony przewód pomiarowy do gniazdka “V
mA", a
czarny do gniazdka “COM” (czerwony przewód ma biegunowość
dodatnią „+”).
2.
Ustawić pokrętło na żądanej pozycji "
".
3.
Podłączyć czerwony przewód pomiarowy do anody, a czarny do katody
diody w celu przeprowadzenia testów.
Pojawi się przybliżony spadek
napięcia w kierunku przewodzenia na diodzie. Jeżeli połączenie
zostanie odwrócone, na wyświetlaczu pokaże się tylko cyfra „1”.
14.
Testowanie ciągłości obwodu
Nie dokonywać pomiaru parametrów diod ani ciągłości w obwodach
znajd
ujących się pod napięciem. Upewnić się, że wszystkie
kondensatory w obwodzie zostały rozładowane.
1.
Podłączyć czerwony przewód pomiarowy do gniazdka “V
mA", a
czarny do gniazdka “COM”.
2.
Ustawić pokrętło na żądanej pozycji "
".
3.
Podłączyć przewody pomiarowe do dwóch końców testowanego
obwodu. Jeśli obwód jest ciągły, wbudowany brzęczyk wyemituje
sygnał dźwiękowy.
15.
Wymiana baterii i bezpiecznika
UWAGA:
Aby uniknąć porażenia prądem elektrycznym, przed
otwarciem obudowy
każdorazowo
należy odłączać przewody
pomiarowe.
Aby zapobiec zagrożeniu pożarowemu, używać
wyłącznie bezpieczników o parametrach określonych w niniejszej
instrukcji.
Uwaga:
patrz ostrzeżenie na gnieździe baterii
W urządzeniu nie występują części, które mogą być serwisowane
przez użytkownika.
W sprawie serwisowania i/lub części zamiennych należy zwrócić się
do autoryzowanego sprzedawcy.
Przed wymianą baterii lub bezpieczników odłączyć przewody
pomiarowe i wyjąć
z gniazd pomiarowych.
Содержание DVM852
Страница 2: ...DVM852 V 01 29 03 2016 2 Velleman nv ...