Velleman CTC1000, Руководство пользователя

Страница: 35 / 219

CTC1000
V. 04 – 11/02/2016 35 ©Velleman nv
the panel will light while this error message can be viewed on
LCD under Fault Display. No alarm event will be reported.
interference • When the system is programmed with Interference detection ON
and when there is an interference detected for 30 seconds, the
yellow LED will light up. The error message can be viewed on
LCD under Fault Display in the user menu.
14.3 Error messages
The error message is displayed in short form as below:
Message displayed Meaning
AC failure AC Power Fail
GSM Signal GSM out of signal
Interference interference detected
Panel L.B. low battery on the control panel
Panel Tamper sabotage on the control panel
(Sensor w/ Zone Name) + L.B. low battery on the sensor
(Sensor w/ Zone Name) + out sensor out-of-order
(Sensor w/ Zone Name) + Tamper sabotage on a sensor
Sim Card? SIM card missing
Example : the message DC Z 01 L.B. means Zone 1 Door Contact is low battery.
Note
While you arm the system, if any of door contact or PIR is triggered, arming is also prohibited and the sensor
triggered will be displayed as error message.
Message displayed Meaning
(DC w/ Zone Name) + open Door Contact triggered
(IR w/ Zone Name) + Active PIR triggered
15. Remote commanding via SMS message
The unit can be controlled by remote control commands sent via sms messages.
Remember to change the Language setting of your mobile phone to English before proceeding.
SMS Remote Control Command Table
Control Command
Action
00 hang up with Confirmation
10 disarm
11 arm
20 UR#1 deactivated
21 UR#1 activated
30 UR#2 deactivated
31 UR#2 activated
For 2-digit Remote Control Command
Send the SMS message to command the Unit to enter Arm Mode and send a confirmation SMS back to your
mobile phone. The format is:
MICHAEL 2222 11 00
MICHAEL
SMS keyword