VELAMP IS342-INCA, Руководство пользователя

Страница: 6 / 24

Attention: In the mounting procedure depicted in Figure B,
make sure that no water can get into the main unit. Make
sure that you mount the unit in a location protected from
rain.
Recommended installation height: 2/3mt max
SOLAR PANEL:
The solar panel is the main power source for the solar light. It
converts sunlight into electricity and charges the battery. When
installing the solar panel, please keep in mind that the solar panel
requires as much DIRECT SUNLIGHT as possible. The longer the
solar cell is exposed to direct sunlight, the longer the light runtime.
To the greatest extent possible, the solar panel should be oriented
to the southern sky in order to maximize exposure to direct
sunlight.
Use the two screws included in the box (3) to mount the solar
panel on a stable, solid supporting surface.
Connect the solar panel cable (2) to the main unit and insert the
plug into the socket (8) situated on the main unit.
2. INSTALLATION with AC / DC TRANSFORMER
The INCA projector can also work with an AC / DC transformer 5V
1A max (smartphone type for example). This allows you to also use
it indoors, near a power outlet and therefore get rid of the solar
panel.
You must therefore connect the USB cable (5) supplied to the
charging jack (8) and then to the charger.
The installation is over.
(5)
FUNZIONAMENTO
USE:
there is one switch (7) on the main unit:
AUTO/ON/OFF
ON: Light always ON
AUTO: automatic ON/OFF: light will turn
on for 2 seconds if motion is revealed in
the covered area
OFF: Light always OFF. This position is ok if
you want to store the device or if you want to fully recharge the battery
for some days.
IMPORTANT: The solar panel must receive as much sunlight as
possible. Place the solar panel in a sunny spot to receive at least 8
hours of sunshine in order for the battery to correctly recharge. The
positioning of the product will affect the duration of illumination:
• 8 hours of sunshine will allow the lamp to work normally.
• In the winter months or on rainy days: as the sun will not be
powerful enough to properly recharge the lamp’s battery, its light
will normally only last for a few minutes.
REPLACING THE BATTERY
If you want to obtain a longer runtime you must change the battery
with a similar type (Li-ion 18650) but with a bigger capacity
(2200mAh or 3250mAh) so as to double or even triple the runtime.
To replace the battery, first remove the device from its supporting
surface. Carefully loosen the cable (2) and remove the battery cover
(6). Remove the battery from the housing and put a new battery in.
Re-assemble the device by reversing this sequence.
Note: During the battery replacement operations, the switch (7) on
the main unit must be set to OFF.
Make sure the correct poles are connected when connecting the
battery. Incorrect polarities can damage the device.
GENERAL SAFETY TIPS
1. Do not use any other solar panel than the one provided. Using
another solar PANEL you may cause injuries or damage to the floodlight
and therefore terminate the warranty.
2.Install the cable in such way that it is secured and cannot create any
kind of hazard (e.g. hazard of tripping). Do not use the solar light if the
cable is damaged or defective.
CLEANING
Keep the motion detector free of dust and deposits by occasionally
cleaning it with a dry cloth or wiping it off with warm, soapy water.
Also, make sure that the solar PANEL is always free of dirt and deposits.
A dirty solar panel cannot completely charge the battery.
This can cause premature aging in the battery and lead to unreliable
function in the device.
STORAGE
in order to prevent damage to the battery please follow these steps if
you are going to store the light for more than two or three days:
1. Set the switch (7) to the OFF-position.
2.Store the light and the solar panel where the panel can receive either
sunlight or indoor light every day. The battery needs light in order to
retain its charge while stored.
3. During long-term storage, the unit must be completely recharged
every four months. In order to preserve complete and proper perfor-
mance, do not store it for long periods without charging the battery.
TECHNICAL DATAS:
Battery: Li-ion 3,7V 1200 mAh
LED: COB LED 10W
Light duration: 25 seconds
Monitored angle: 180º
Range: max. 8 meters
Runtime:
• Always ON: 50 minutes, maximum
• AUTO: 100 times 25 seconds.
MANUALE_DEF.indd 6 22/05/20 13:55