Veho MUVI Q-1, Руководство пользователя

Страница: 12 / 19

22
6.4 Failsafe protections
If the Q-1 Drone loses signal from the controller the Automatic Flight Control System will
return it to the home point* and land safely. This reduces the chances of the Q-1 Drone
getting lost or crashing in case the controller signal is lost.
*The home point is the Q-1 Drone’s position where the Q-1 Drone successfully scanned and
connected to the satellite. To ensure that the Q-1 Drone successfully flies back to the home
point if it enters failsafe mode please only take-off after the Q-1 Drone’s GPS has successfully
connected to the satellite.
If you lose control of the Q-1 Drone during flight the Q-1 Drone will automatically follow
the procedure below:
1. The Q-1 Drone will automatically slow down and hover in one location.
2. If the Q-1 Drone regains signal from the controller within 2 seconds it will return to
normal flight mode and will not enter failsafe mode.
3. If the Q-1 Drone does not regain signal from the controller within 2 seconds it will enter
failsafe mode and will initiate automatic flight control to return to the home point.
• The Q-1 Drone will continue to hover for 15 seconds and will evaluate the vertical
distance to the home point
• If the distance is more than 15 metres the Q-1 Drone will commence flying back to
the home point.
• If the distance is less than 15 metres the Q-1 Drone will fly up vertically until it is
15 metres higher than the home point and then commence the return.
• When the Q-1 Drone reaches the home point it will hover for 5 seconds and then
automatically land.
PLEASE NOTE: The Q-1 Drone cannot automatically avoid obstacles in its path while it
is in failsafe mode.
23
6.5 How to regain control on the controller
If the Q-1 Drone is out of control toggle the S4 switch on the controller several times to
switch flight mode. When the signal is restored, the controller will regain control and you
can continue to use the controller to operate the Q-1 Drone.
6.6 Battery level alarm function
When the Q-1 Drone battery charge is low you must land it as soon as possible or else it may
lose power completely and crash. The Q-1 Drone has a two level battery alarm function.
Level 1 is a low power alarm and level 2 is a severe low power alarm. Both levels are
indicates by the flight indicator lights:
Low power Flight indicator light status Low power risk prompt
alarm level
Level 1 The 2 front indicators and the 2 rear In level 1 alarm condition the Q-1 Drone will
indicators will flash slowly. fly normally for a few minutes and then
initiate the level 2 alarm.
Be careful while flying, keep the Q-1 Drone
within sight and do not fly to high or too far.
Level 2 The 2 front indicators and the 2 rear In level 2 alarm condition the Q-1 Drone will
indicators will flash quickly. fly normally for a few minutes and initiate
the failsafe mode and start to automatically
land.
When in level 2 alarm condition please
return and land the Q-1 Drone as safely as
possible and do not push the throttle hard
or make big movements during flight.
During low power automatic landing you can regain control of the Q-1 Drone by switching
the flight mode (S4 switch). However do not do so repeatedly as it may reduce the battery
life or the Q-1 Drone may crash due to insufficient power.