DOC. NO. 5956.6K6.00
P. 7 / 28
5.1
Counters
Sym.
Parameter Description
Unit
Min
Max
Factory
Default
Cycles performed counter.
symbol and two numbers blink consecutively. The cycle number
is obtained by joining the two numbers.
Ex.
→
→
means 10042 cycles executed.
-
Cycle counter (resettable).
This counter is similar to
but is resettable by user (see
parameter below).
-
Water Consumption (only for dishwashers with incorporated continuous
water softener).
Counts m
3
of water consumption.
[m
3
]
Water Consumption (only for dishwashers with incorporated continu-
ous water softener).
Counts litres of water consumption.
The total consumption is given by adding
[m
3
] and
[l] values.
[l]
Water Consumption: resettable counter. [present up to software version
3.12]
Counts the litres of water and is resettable by user (see
parame-
ter below).
[l]
Reset resettable counters:
and
To reset put 1 this parameter, switch off and then on again:
and
will show zero. Note that
is used to count cycles for
message (see next parameter,
).
-
Store thousand of cycles after that
message appears on dis-
play.
Ex. If this parameter is settled to 20,
message appears when
reach 20.000 cycles.
-
Drain/Cleaning cycles performed.
Similar to
but counts Cleaning Cycles.
-
Numbers of cycles that can be made after a regeneration cycle (only for
dishwashers with non-continuous water softener) [See paragraph 9.1
DETERGENT AND RINSE AID LEVEL SENSORS ACTIVATION.].
-
20
Regeneration cycle counter (only for water softener dishwasher)
[See paragraph 9.2 DISHWASHERS WITH WASH TANK WATER
CHANGE FREQUENCY CONTROL].
only counts efficient
regeneration cycles, i.e. those carried out with salt in the special con-
tainer (only for dishwashers with incorporated continuous water sof-
tener)
-
Counter of regeneration cycles done without salt in the special con-
tainer. (only for dishwashers with incorporated continuous water sof-
tener) [See paragraph 9.2 DISHWASHERS WITH WASH TANK
WATER CHANGE FREQUENCY CONTROL].
-
