DOC. NO. 5956.6K6.00
P. 4 / 28
2 MANUAL ACTIVATION OF DETERGENT AND RINSE AID DISPENSERS
When replacing detergents may be necessary activate the dispensers to fill hoses.
2.1
Detergent Dispenser Activation
2.2
Rinse Aid Dispenser Activation
3 RINSE PUMP MANUAL ACTIVATION
Use this function to empty the boiler (if the dishwasher is not to be used for a long time, for maintenance oper-
ation: ex. before replacing main board).
4 DETERGENT AND RINSE AID DOSAGE
In this paragraph is explained how to set the working time for the detergent and rinse aid dispensers.
For each dispenser there are two parameters: the initial time and the time during cycle execution.
4.1
General Parameters
How change the duration:
•
Switch OFF and switch ON the dishwasher;
•
Enter into the USER SETTING mode by pressing and hold down ON/OFF and BUTTON_1 keys for at least
five sec-
onds
the display shows
(Figure 9);
Switch on the dishwasher.
Press and hold down BUTTON_2 and
BUTTON_3 keys, after two 'beep' the
detergent dispenser starts work for 20
sec.
Switch on the dishwasher.
Press and hold down BUTTON_1 and
BUTTON_3 keys, after two 'beep' the
rinse aid dispenser starts work for 40
sec.
Switch on the dishwasher.
Close the door and press and hold
down DRAIN and BUTTON_3 keys. A
buzzer signal indicates the rinse pump
activation and the display shows three
blinking lines. Three beeps indicate
the cycle end.
TANK
BOILER
dEt
1
2
3
TANK
BOILER
rAi
1
2
3
TANK
BOILER
---
1
2
3
Sym.
Parameter Description
Unit
Min
Max
Factory Default
Initial Detergent Dosage (during filling tank)
[s]
0
240
90
Initial Rinse Aid Dosage (starts when tank filled)
[s]
0
180
10
Detergent Dosage During Cycle Execution (during wash
phase)
[s]
0
182 (*)
8
Rinse Aid Dosage During Cycle Execution (when refill-
ing boiler)
[s]
0
62 (*)
4
