EMR
3
Setup and Operation Manual
C&C Mode Setup Categories
36
Figure 40. Product Description Setup
Press ENTER to return
to FUEL SOURCE
Press ENTER to accept
choice and return to
Record Prod Cal numbers assigned to
each of the Product Descriptions
ENTER
ENTER
PRODUCT DSCRIP
PROD DSCRPT 1
PROD DSCRPT 8
NEXT
PRODUCT NAME
NEXT
PRODUCT NAME
ENTER
-
+
TEMPERATURE COMPENSATION*
CAL NUMBER
PRODUCT TYPE
PRODUCT NAME
NEXT
GASOLINE
DIESEL
LPG
KEROSENE
AV GAS
FUEL OIL
CRUDE OILS
LUBRICATING OILS
USER DEFINED
NO PRODUCT ENTRY
-
+
NEXT
NEXT
NEXT
NEXT
NEXT
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
*Note: Coefficient or Density will display depending
on choice made in Delivery Options setup
Noncompensated
TC Compensated
PROD CAL 1
PROD CAL 2
PROD CAL 3
PROD CAL 4
-
+
-
+
-
+
COEFFICIENT X ˚F
TEMPERATURE X ˚F
-
+
NEXT
FORMAT 1
FORMAT 2
-
+
DENSITY X ˚F
TEMPERATURE X ˚F
(existing)
(new)
Accept or change the default
name, pressing up/down arrows
to scroll through the alphabet,
and NEXT to move from one
character of the name to the
next. Press ENTER to accept
choice.
Up to 8 Products Can be Assigned
Make your changes to the coefficient in
Preset field (if necessary) and/or to
temperature in Register field (if necessary).
To make change press up/down arrows to
scroll through the numbers, and NEXT to
move from one digit of the entry to the next.
Note: refer to the table in the Meter
Calibration setup in which you
entered the products used for each
of the four PROD CALs.
Selection applies to both shift
and delivery tickets
Default Product Types - See Table 2 for coefficients, or Table 4
for densities for these product types.
User Defined - a liquefied gas not available in the tables can
be set up under User Defined. However, you will need to enter
either coefficients (ref. Table 3) or densities (ref. Table 5) for
the product.
No Product Entry - Once you have used one of the 8 Product
Descriptions and decide to no longer use it, you must choose
this selection for that Product Description.
See Table 3 for coefficients.
1
1
1
2
1
4
1
1
1
1
1
3
4
3
2
2
3
4
OR
Displayed coefficient of expansion corresponds to
default Product Type selected (see Table 2).
Displayed density corresponds to default
Product Type selected (see Table 4).
1
3
4
2
For LPG or USER DEFINED Product Types, 12
coefficient-temperature pairs are required (see
Table 3).
For LPG or a USER DEFINED liquefied gas, 12
density and temperature pairs are required (see
Table 5). For optimal accuracy, the selected data
points should include temperatures warmer and
cooler than the range measured during typical
dispensing.
TC Compensated only appears
if the temperature probe is
installed.
1
1
PROD DSCRPT #
PROD CAL #
1
2
3
4
5
6
7
8
