Appendix B
Datalogger Site Connection and Initialization
B-7
Figure B-6. Entering ATG Command
Click on the DIM Command page and then click on the trash can icon on the right end of the i@C300 command
line to delete the i@C300 command (see Figure B-7). Jump back to the “General Setup” application by clicking on
arrow top center of screen.
Figure B-7. Deleting ATG Command
10. Select “TDIM” set-up. Select “TDIM (ETH1)” from the drop-down menu. On the “TDIM Enable” drop down,
select “TRUE” and type in a label (maximum of 20 characters). Then select the DIM protocol being used and
click “Save”. Accept the default Listen Port (unless there is a conflict with another device) and select the
desired units (see example in Figure B-8). Once this is complete, click on “Save” to keep these settings.
i@C
3
00
DIM_EVENTS
60
1
2
4
3
Select
Click and delete
Click to jump to the GeneralSetup application
