3
Installing the Dispenser Pan Sensor
This section describes the hardware, requirements, wiring guidelines, and procedures
for installing the Dispenser Pan Sensor with Dispenser Control Interface.
Installation Hardware
The Stand-Alone Dispenser Pan Sensor with Dispenser Control Interface comes with
the following installation hardware:
For applications which require UL listing:
❑
Veeder-Root Non-Discriminating Stand-Alone Dispenser Pan Sensor with
Dispenser Control Interface
Part No. 847990-001 (Float-Switch Type)
❑
Veeder-Root Discriminating Stand-Alone Dispenser Pan Sensor
with Dispenser Control Interface
Part No. 847990-002 (Differentiating type)
For applications which require cUL listing:
❑
Veeder-Root Non-Discriminating Stand-Alone Dispenser Pan Sensor with
Dispenser Control Interface
Part No. 847970-001 (Float-Switch Type)
❑
Veeder-Root Discriminating Stand-Alone Dispenser Pan Sensor
with Dispenser Control Interface
Part No. 847970-002 (Differentiating Type)
For both:
❑
1 Wiring Kit (Part No. 330020-024)
❑
Installation Instructions
Important
☞
Mounting brackets are required and must be ordered separately. Use of
Veeder-Root
Universal Mounting Kit (Part No.
330020-012
) is recommended.
Installation Requirements
Before you install each Dispenser Pan Sensor, consider the following important
requirements:
1.
The sensor should rest in the cup or lowest point of the dispenser pan.
2.
It is recommended that the sensor be mounted in a true vertical position to ensure
proper operation of the sensor.
3.
Ensure that there will be enough room to pull the sensor straight out of the pan if
service is required.
